Helping You Connect the Dots to Succeed Faster
www.InnoDraw.com
www.WGAN.info/fotello
Last 24 Hours: 830 Unique Visitors
9,444 WGAN Members in 149 Countries
Last 30 Days: 16,978 Page Views | 10,108 Unique Visitors | 14 New Members
We Get Around Network Forum
Quick Start | WGAN Forum
Advice

Scan point displays as Blue with lines2358

LewisBishop private msg quote post Address this user
I have one scan point that displays as above. I've never seen this.

The problem is that it's a midway point in hallway so if I hide it the transition is not smooth.

What to do? Do you think re-processiing would fix?


Post 1 IP   flag post
CarlosFHdz private msg quote post Address this user
Hi @LewisBishop , I've had glitches similar to that when editing on workshop mode, but they haven't appeared on the model outside of Workshop mode. Try it out. I would recommend reprocessing as well.

Carlos.
Post 2 IP   flag post
LewisBishop private msg quote post Address this user
@CarlosFHdz,

The say patience is a virtue. After a few minutes I reloaded workshop mode and it went away.
Post 3 IP   flag post
106555 3 3
This topic is archived. Start new topic?